Maintenance methods and requirements for diamond saw blades

Maintenance method of diamond saw blade:

1. If the diamond saw blade is not used immediately, it should be laid flat or hung by the inner hole. No other objects or footsteps should be stacked on the flat diamond saw blade, and attention should be paid to moisture and rust prevention.　

2. When the diamond saw blade is no longer sharp and the cutting surface is rough, it must be re-grinded in time. Grinding cannot change the original angle and destroy the dynamic balance.　　

3. The inner diameter correction and positioning hole processing of the diamond saw blade must be carried out by the manufacturer. If the processing is poor, it will affect the product use effect and may cause danger. In principle, the hole expansion should not exceed the original diameter of 20mm, so as not to affect the balance of stress.

Diamond Saw Blade for Marble Slab block Cutting

Requirements for the use of diamond saw blades:

1. When working, ensure that the workpiece is fixed and the profile is positioned in accordance with the direction of the knife to avoid abnormal cutting. Do not apply side pressure or curve cutting. The knife should be smooth to avoid the impact of the blade contacting the workpiece, which may cause damage to the saw blade or The workpiece flew out and an accident occurred.　　

2. During work, if abnormal sound and vibration, rough cutting surface, or peculiar smell are found, the operation must be terminated immediately, and the fault must be checked in time to avoid accidents.　　

3. When starting and stopping cutting, do not feed the tool too fast to avoid broken teeth and damage.　　

Asphalt Concrete Cutting Diamond Saw Blades

4. If cutting aluminum alloy or other metals, special cooling lubricants should be used to prevent the saw blade from overheating, generating paste teeth, and other damage, which affects the cutting quality.　　

5. The equipment chip trough and slag suction device ensure unobstructed, to prevent the accumulation of slag and block, which affects production and safety.　　

6. When dry cutting, please don't cut continuously for a long time, so as not to affect the service life and cutting effect of the saw blade; wet cutting should be cut with water to prevent leakage.