How to replace the small diameter saw blade from the machine
So, how to replace the saw blade?
Interpretation of the steps of cutting machine changing saw blade:
- When the saw blade of the cutting machine is chipped, deformed or cracked, it must be replaced. Turn off the main power supply or remove the plug. Be foolproof.
- Then find the position of the rotating shaft of the saw blade of the cutting machine. One end of this shaft is the saw blade, and the other end is the pulley. In the middle is the bearing housing.
- In the middle of the bearing box, there is a cylinder protruding from the surface of the box. This is the shaft locking device. Its principle is to press the cylinder and turn the shaft with the other hand. The direction of rotation does not matter. A better way is to swing the shaft left and right by hand. After the cylinder pressed at the same time meets the small hole on the shaft, the cylinder pin enters the hole. The shaft cannot be turned.
- Press the cylinder at this time, and use the adjustable wrench with the other hand to loosen and remove its fastening bolt. Remove the protective disc and the paper pad in turn, and the damaged saw blade. Don’t take out the protective disc inside. Put a new granite saw blade Put it in, and then install the paper pad and the protective disc in sequence.
- Fasten the bolts.How to change the saw blade of the cutting machine Even if the saw blade is replaced, you must pay attention to it when you use it again. Learn more about the basic knowledge of using the cutting machine. Only when you have some understanding of the saw blade can you operate and other applications. It is strictly prohibited to operate blindly to cause loss.
The above is a little knowledge of how to replace the saw blade of the cutting machine. If you want to know more clearly, you can consult us.
How to exchange hot press saw blades for cutting machines is what we often encounter The problem is that due to the variety of cutting machines and the level of saw blades, how do boreway manufacturers change wet cutting saw blades is a more troublesome question.
