I use the same machine and grinding disc as others, why the processing effect is different?

1. The large-scale grinding machine can significantly improve the construction efficiency, and the metal grinding block (Husqvarna 2 Segment Diamond Grinding Bar For Suppliers) or thick abrasive discs can make the ground flatness better, good flatness can reduce the difficulty of later construction, easy to make a beautiful hardened floor, especially after polishing, the effect is more obvious;

2. Poor ground flatness will cause uneven grinding; even if the surface is hardened when the hardness is not enough, the overall strength and brightness will not be satisfactory.

In this case, it is recommended to use One Rectangle Metal Bond Segments Grinding Bar or concrete thick grinding Flatten the ground as much as possible, cut off the loose surface layer, make the hardness of the ground base layer meet the construction requirements, so as to reduce the consumption of the grinding plate in the later grinding and make the treatment effect better. If necessary, consider the secondary hardening treatment.






3. Grasp several principles for the use of grinding discs: Use metal grinding blocks for ground leveling and rough grinding (Quick Change Z Segment Bar For Suppliers) or concrete thick grinding discs; when fine-sand grinding discs can be used, coarse sanding discs are not required; increasing the grinder weight or increasing the speed can improve efficiency; try not to skip the number of grinding discs; be sure to polish Wash the floor, dry it, and then dry it; use a sponge polishing sheet to improve the brightness of the floor; when there is a higher requirement for the brightness of the floor, you can use a concrete brightener.